Steel band balers use steel strips to wrap products or packages, then press the tightening key to tighten the excess steel band so that the steel band is tightly attached to the product or package, and then melted by heat or steel buckles are used to turn the steel. With two sides connected machine. The main function of the steel strapping machine is to enable the steel straps to cling to the surface of the products or packages that are being strapped to ensure that they are not scattered due to loose binding during transportation and storage, and also have the function of making the products strapped neatly and beautifully; Messy display, saving storage space.
Steel strap baler classification free buckle strap baler is generally suitable for flat packaging. For example, boxes, pallets, and other similar types of packaging. The buckle-free steel belt baler does not require the use of additional steel buckles; its characteristics are mainly that the average tensile strength of the no-buckle connection is about 80% of the tensile strength of the steel strip, is very reliable, and can save about 10% of the overall packaging cost . Universal steel tape packaging tools used in almost all areas are reliable, robust, easy to handle and lightweight, and are now widely used.
The manual steel strapping press is known for its small size, easy to carry and durable. Widely used in various industries. It is used after the combination of an accelerator and a snap fastener. General specifications are 12mm, 16mm, 19mm, 25-32mm. And the gap between the friction wheel and the padding wheel is between 0.5-0.7mm, otherwise it should be adjusted, and the accumulated debris and dirt on the friction wheel should be promptly removed.
The difference between the pneumatic steel balers and the manual balers is that the former is equipped with a motor and should be filled with oil before use. It has certain requirements for air pressure, otherwise it will affect the packaging effect.
Precautions for use Before use, check the power supply used by the machine. Do not plug in the wrong power supply. This machine adopts three-phase four-wire system. The flower line is the grounding zero line (for the earth line), for leakage protection; do not put the head hand through the runway of the belt during the operation; do not directly touch the heating plate; do not rinse the machine with water, the workplace is wet The operator should not work barefoot; when the machine is not in use, please rewind the tape inside the storage bin to the reel to avoid deformation during the next use; remember to unplug the power when the machine is not in use; and the machine must not use a non-grounded power supply.
Steel strap baler faults and troubleshooting methods Due to the wear of the parts during work, the reason for the loosening of the pressure of the gas source due to loose screws, and the malfunction of the machine, it is necessary to remove them in time so that the machine can work normally and smoothly. The causes of the faults are as follows.
1. In the air motor and the cylinder body and in all the transmission and rotating parts, before the shift is used, an appropriate amount of lubricating oil must be injected. In addition, the 22# gas turbine oil should be filled regularly and quantitatively in the oil injector to keep it fixed. When the air motor is working, the drop of oil from the oiler is 40-60 drops/min.
2. If the compressed air does not match 0.4-0.6Mpa, it must be adjusted. Otherwise, too low pressure will affect the quality of the strapping. Excessive pressure will cause the machine to wear too quickly.
3, oiler, oil and water separator every use of kerosene cleaning once every three months, and remove the water in the water separator.
4. The clearance between the friction wheel and the padding wheel is between 0.5-0.7mm, otherwise it should be adjusted, and the accumulated dust and dirt on the friction wheel should be promptly removed.
5, due to long-term wear of parts, environmental pollution, poor lubrication, failure may occur, and it is important to find faults, timely removal, the following inspections and repairs, use of common tools can be resolved, can grasp the following technology It will not stop production due to minor faults, lose precious time when shutting down machines, and turn to the manufacturer.
